Sherwin-Williams 824175 A Series Manuel du propriétaire télécharger pdf (Page 16)

16 824113

Drive Housing, Connecting Rod, Crankshaft

Torque to 2.4 N.m (21 in–lb)

Fig. 15





 Quantity of three

Quantity of one

Apply a total of 3 fl. oz.(29 cc)

of grease to gears.



5,6

12a

12b

11a

REF A

Note: Filter

not shown

02815









Pressure Control

Relieve pressure; page 3.

NOTE: See Fig. 16 for this procedure.

NOTE: The pressure control (64) cannot be repaired

or adjusted. If it has malfunctioned, replace it.

1. Remove the front cover (13). Remove the screws

(56). Lower the junction box (59).

2. Disconnect the harness connector (A) from the

motor start board (47).

3. Remove the screws (63). Pull forward on the

pressure adjusting knob and tip the pressure

control (64) forward and up to detach it from the

drive housing (11).

4. Guide the harness (A) through the motor and drive

housing and remove the pressure control.

5. Guide the harness of the new pressure control

through the drive housing and motor passages.

6. Install the new pressure control. Tip the pressure

control down and back into the drive housing (11).

Do not pinch or damage the harness (A).

7. Loosely install the screws (63) and then torque

them to 21 in–lb (2.4 N.m).

8. Install the front cover (13). Connect the harness

(A) to the motor start board (47).

9. Install the junction box. Be sure no leads are

pinched against the motor or by the motor start

board.

Torque to

21 in–lb (2.4 N.m)

Fig. 16



02816A

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Sherwin-Williams 824175 A Series Manuel du propriétaire Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Pulvérisateur de peinture Sherwin-Williams 824175 A Series